PLATO 170 Wire Cutter – Special Cutters Electronic Diagonal Cutting Plier
- Ultra-High Hardness
- Flush Wire Cutters has an 13mm long chrome vanadium steel jaw with angled head design. They are ideally sized for working in small spaces and improving your productivity.
- Super-Sharp Blade
- Flush Wire Cutters are very sharp, induction hardened cutting edges without bevel for flush cutting. They offer extremely smooth movement for minimum operator fatigue.
MQ-4 Natural Gas Methane Gas Sensor Module
- Detecting range: 300~10000ppm
- Signal output indicator.
- Dual Signal output (analog output and TTL output).
- The TTL output signal is low level, allows us to connect with SCM directly.
- Analog output 0~5V voltage.
- Quick response and recovery.
INA226 DC Voltage and Current Sensor Power Monitoring Module
- Bidirectional current monitoring
- High accuracy
- IIC interface for easy connectivity
- Compact and robust design
- Wide current measurement range
CJMCU-3221 INA3221 Triple-way Low Side / High Side I2C Output Current Power Monitor Module
- Senses bus voltages from 0 V to 26 V
- Reports shunt and bus voltage
- High accuracy
- Offset voltage: ±80 μV (max)
- Gain error: 0.25% (max)
- Configurable averaging options
- Four programmable addresses
- Programmable alert and warning outputs
- Power-supply operation: 2.7 V to 5.5 V
Official 7Semi DC Buck Converter Breakout 3.8V 2A Out (AP62301)
-
Fixed 3.8V DC Output
-
Up to 2A Continuous Current
-
Based on AP62301 Synchronous Buck Converter
-
Wide Input Voltage: 4.2V–14V DC
-
High Efficiency Step-Down Regulation
-
Low EMI Optimized Design
-
High Switching Frequency up to 2.2MHz
-
Ultra-Compact 18 × 16 mm PCB
-
Stable Output for Battery-Powered Devices
-
Ideal for IoT & Embedded Applications
Official 7Semi DC Buck Converter Breakout 3.3V 2A Out (AP62301)
-
Fixed 3.3V DC Output
-
Up to 2A Continuous Output Current
-
Based on AP62301 Synchronous Buck Converter
-
Wide Input Voltage Range: 4.2V–14V
-
Low EMI Optimized Design
-
High Efficiency Step-Down Conversion
-
Low Output Ripple & Stable Regulation
-
Built-In Over-Current & Over-Temperature Protection
-
Soft-Start for Safe Power-Up
-
Ideal for IoT, Embedded & Battery-Powered Applications
Official 7Semi DC Buck Converter Breakout 5V 2A Out (AP62301)
-
5V DC output with up to 2A continuous current
-
Wide input voltage range: 7V to 14V DC
-
AP62301 synchronous buck converter IC
-
Low EMI design for noise-sensitive applications
-
High efficiency with low output ripple
-
Compact 18 × 16 mm breakout board
-
Built-in protection: over-current & over-temperature
Core Board STM8S103F3P6 STM8 Development Board Minimum System Board
- Chipboard STM32F103C8T6
- On board, SWIM interface and reset button
- Micro USB line or the 2.54 pin to link to the power with the input voltage 4.5V-15V.
- Power light and the Demo indicator light
- Leads all the pins and has detailed label for the Pins.
- Support SWIM debug mode.
ACS712 20A Range Current Sensor Module
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 20A
- Sensitivity: 100mV/A
MQ-135 Air Quality Sensor Detection Module
- Sensitivity to Ammonia, Sulphide and Benzene steam
- Sensitive for benzene, alcohol, smoke
- Fast response and recovery
- Adjustable sensitivity
- Signal output indicator
- Output voltage boosts along with the concentration of the measured gases increases.
GY-45 MMA8452 3-Axis Accelerator Module
- Operating Voltage: 3-5VDC
- 3 Axis Accelerometer Module
- Compatible With Arduino and Raspberry Pi
- Two Interrupt Pins
- Communication Via I2C Bus
TTP226 8-way Capacitive Touch Switch Module
- Onboard 8 key TTP226 capacitive touch induction IC.
- Onboard 8-way level indicator.
- Working voltage: 2.4 to 5.5 V.
- Modules, you can set the output mode, key output mode, the longest time and fast/low power output
28BYJ-48 12V 4-Phase Stepper Motor
- Rated voltage: 12V DC
- Reduction Ratio: 64:1
- Step Angle: 5.625° /64
- Frequency: 100Hz
- Self-positioning Torque: >34.3mN.m
- Friction torque: 600-1200 gf.cm
- Pull in torque: 300 gf.cm
MQ-3 Alcohol Ethanol Detection Sensor Module
- Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
- Current Consumption: 150mA.
- DO output: 0.1 and 5V.
- AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detecting Concentration: 0.05-10mg/L Alcohol.
MQ-7 CO Carbon Monoxide Coal Gas Sensor Module
- Operating voltage: DC 5 V.
- The analog output voltage, the higher the concentration the higher the voltage.
- The carbon monoxide detection with better sensitivity.
- With a long service life and reliable stability.
- Rapid response and recovery characteristics.
- Range: 10 to 1000 ppm.
MQ-9 CO Carbon Monoxide methane liquefied Gas Sensor
- Good sensitivity to CO/Combustible Gas
- High sensitivity to Methane, Propane, and CO
- Long life and low cost
- Simple drive circuit
- Input voltage: DC 5±0.2V
- Current Consumption: 150mA
PL2303 USB to TTL RS232 Module (USB to Serial Cable)
- Built-in TTL COM PC-PL2303 Chip.
- Standard USB type and TTL 4 pin connector
- Simple and Easy way to give USB support to your designs
- Available for Linux, Mac, WinCE, and Windows (XP, 7), Win 8
- Cable Length: 1M
- Net Weight: 30gm
3.3-5.5V HC-SR04+ Ultrasonic Sensor 4pin
- Power Supply +5V DC
- Working Current 15mA
- Output Signal Electrical frequency signal
- Ranging Distance 2cms – 400 cms
- Resolution 0.3 cm
TTL to RS485 Power Supply Converter Board 3.3V 5V Hardware Auto Control Module
- Anti-Interference Ability
- Baud rate: 110 ~ 256000bps
- Operating Voltage: 3v to 30VDC
- Compatible With Both 3V and 5V logic
3.7V 500mAH (Lithium Polymer) Lipo Rechargeable Battery (Model – YXL-551145P)
- Battery Model: KP-551145
- Material: Lithium Polymer
- Battery Type: KP-600938 Rechargeable Power Battery
- Voltage: 3.7V
- Capacity: 450 mAh
- No memory effect
- Environmentally friendly
