Home » Shop

Showing 321–340 of 684 results

LM393 Test Motor Speed Counter Sensor Groove Coupler Encoder Module

SKU: SEN0136
Original price was: ₹101.00.Current price is: ₹35.00. (Excl. 18% GST)
  1. Using imported groove optical coupling sensor, width 5mm.
  2. It has the output state light, if output high level, the lights are off. if output low level, it on.
  3. If it covered, it will output high level; otherwise, its output low level.
  4. Good signal and waveform, with a strong driving ability for more than 15mA.
  5. Equipped with a fixed bolt hole, easy install.
  6. Use the LM393 wide voltage comparer.
Add to cart

LM35D Analog Temperature Sensor Module + Cable

SKU: SEN0105
Original price was: ₹436.00.Current price is: ₹116.00. (Excl. 18% GST)
  1. Based on the semiconductor LM35 temperature sensor
  2. Can be used to detect ambient air temperature
  3. Calibrated directly in °Celsius (Centigrade)
  4. Linear + 10 mV/°C Scale Factor
  5. 0.5°C Ensure accuracy (at +25°C)
  6. Low power consumption, less than 60uA
  7. Low output impedance, 1mA current through only 0.1Ω
  8. With screw holes for easy installation and fixed. Aperture 2.6mm
Purchase & earn 1 point!Add to cart

LM2596S DC-DC Buck Converter Step Down Module – Variable Voltage (3A BUCK 3-40V TO 1.5-35V)

SKU: POW0022
Original price was: ₹199.00.Current price is: ₹39.00. (Excl. 18% GST)
  • Input Voltage(VDC): 4 ~ 40.
  • Output Voltage(VDC): 1.3 ~ 37.
  • Output Current: 2A Rated, ( 3A maximum with heat sink).
  • Switching Frequency: 150 kHz.
  • Input reverse polarity protection.
  • Built-in output short protection function.
Add to cart

LM2577S+LM2596S Automatic Buck-Boost Power Module (Solar Energy Step-down and Step- up Module) (RED)

SKU: POW0025
Original price was: ₹499.00.Current price is: ₹269.00. (Excl. 18% GST)
  • Input : 3.5-28 Volts.
  • Output : 1.25 Volts – 26 Volts.
  • Output voltage independent of input voltage (3.5V-28V input, any value output 1.25V-26V).
  • Maximum input current 3 Ampere.
  • Maximum output 3 Ampere.
  • Rated input 1 Ampere, Output 1 Ampere.
  • Size : 5.2cm x 3.8cm x 2cm
Purchase & earn 3 points!Add to cart

LED Scroller Matrix keyboard

SKU: SEN0192
Original price was: ₹250.00.Current price is: ₹142.00. (Excl. 18% GST)
  • Switch Type: Momentary
  • Pin Spacing (mm): 2.54
  • Module Dimensions (L x W x H): 57 x 33 x 6
  • Weight: 10gm
  • 4×4 Matrix Keyboard Module with 16 buttons
Purchase & earn 1 point!Add to cart

LCD2002 Display With Blue Backlight

SKU: DIS0054
Original price was: ₹450.00.Current price is: ₹319.00. (Excl. 18% GST)
  1. Model: LCD2002
  2. Character Color: Black
  3. Backlight: Blue
  4. Supply voltage: 5V
  5. Dimensions:: 116 x 37 x 13.5(mm)
  6. Characters: 20
  7. Rows: 2
Purchase & earn 3 points!Add to cart

LCD1604 Blue Backlight Display – 16×04 LCD Display Module

SKU: DIS0052
Original price was: ₹498.00.Current price is: ₹350.00. (Excl. 18% GST)
  • HD44780 compatible Driver IC
  • Input Voltage: 5V
  • Resolution: 16×4 characters
  • Backlight Color: Blue
  • Pixel Color: White
Purchase & earn 4 points!Add to cart

LCD1602 Parallel LCD Display Yellow Green Backlight 5V

SKU: DIS0048
Original price was: ₹165.00.Current price is: ₹88.00. (Excl. 18% GST)
  1.  16×2 LCD (16 characters per line, 2 lines).
  2.  Shows white characters on a yellow background.
  3. Equipped with a backlight for enhanced visibility in low-light conditions.
  4.  Easily interfaces with Arduino and other microcontrollers.
  5.  Suitable for a wide range of applications requiring basic text display and user interaction.
Purchase & earn 1 point!Add to cart

LCD1602 Parallel LCD Display with Grey Backlight

SKU: DIS0050
Original price was: ₹263.00.Current price is: ₹140.00. (Excl. 18% GST)
  1.  16×2 LCD (16 characters per line, 2 lines).
  2.  Shows white characters on a grey background.
  3. Equipped with a backlight for enhanced visibility in low-light conditions.
  4.  Easily interfaces with Arduino and other microcontrollers.
  5.  Suitable for a wide range of applications requiring basic text display and user interaction.
Purchase & earn 1 point!Read more

LCD1602 Parallel LCD Display with Blue Backlight with Soldering

SKU: DIS0049
Original price was: ₹190.00.Current price is: ₹110.00. (Excl. 18% GST)
  1.  16×2 LCD (16 characters per line, 2 lines).
  2.  Shows white characters on a blue background.
  3. Equipped with a backlight for enhanced visibility in low-light conditions.
  4.  Easily interfaces with Arduino and other microcontrollers.
  5.  Suitable for a wide range of applications requiring basic text display and user interaction.
Purchase & earn 1 point!Read more

LCD1602 Blue Backlight 5V (AIP31066 Chip)

SKU: DIS0047
Original price was: ₹165.00.Current price is: ₹88.00. (Excl. 18% GST)
  1. Display Contents: 16 * 2 Characters (5*8 dots ) (16 characters per line, 2 lines).
  2.  Shows white characters on a blue background.
  3. Equipped with a backlight for enhanced visibility in low-light conditions.
  4. Driver IC: AIP31066
  5. Interface: Parallel
  6. Operating Temperature: -20 C-﹢70 C
  7. Storage Temperature: -30 C-﹢80 C
Purchase & earn 1 point!Add to cart

LAUNCHXL-F28069M Piccolo F28069 MCU, InstaSPIN-MOTION & InstaSPIN-FOC, Motor Control

SKU: DEV0099
Original price was: ₹7,999.00.Current price is: ₹4,192.00. (Excl. 18% GST)
  • Support for InstaSPIN-FOC and InstaSPIN-MOTION

  • USB-powered development environment

  • On-board JTAG emulator for easy debugging

  • Compatible with multiple TI BoosterPacks

  • Designed for sensorless field-oriented control of PMSM, ACIM, and BLDC motor

Purchase & earn 42 points!Add to cart

LAUNCHXL-F280049C – C2000 Piccolo MCU F280049C LaunchPad Development Kit

SKU: DEV0049
Original price was: ₹8,473.73.Current price is: ₹5,399.00. (Excl. 18% GST)
  • TMS320F280049C: 100 MHz C28x CPU with FPU and TMU, 256 KB Flash, InstaSPIN-FOC enabled, 3x 12-bit ADC, CAN, encoder, FSI, UART, and more
  • On-board XDS110 debug probe for real-time debug and flash programming
  • 80 pin LaunchPad leveraging the BoosterPack ecosystem
  • Power domain isolation for real-time debug and flash programming
  • Isolated CAN transceiver
  • Two encoder interface connectors
  • FSI interface connector
  • Hardware Files are in C2000Ware at boards\LaunchPads\LAUNCHXL_F280049C
Purchase & earn 54 points!Add to cart

LAUNCHXL-F2800157 – C2000 MCU F2800157 LaunchPad Development Kit

SKU: DEV0100
Original price was: ₹7,999.00.Current price is: ₹3,843.00. (Excl. 18% GST)
  • Microcontroller: TMS320F2800157
  • Clock Speed: 120 MHz
  • Debugger: XDS110 Onboard
  • Connectivity: USB, GPIO, BoosterPack headers
  • Operating Voltage: 3.3V / 5V compatible
Purchase & earn 38 points!Add to cart

L298N Dual H Bridge DC Stepper Motor Driver Board

SKU: COMP0030
Original price was: ₹319.00.Current price is: ₹187.00. (Excl. 18% GST)
  1. Driver chip: L298N Dual H Bridge
  2. Supply voltage: VMS 5V – 35V
  3. Peak current IO: 2A per bridge
  4. Max power consumption: 20W
  5. Provides 4 LEDs that reflect the state of the control logic
  6. Independent direction, speed, and braking for each motor
Purchase & earn 2 points!Add to cart

L298N 5V Motor Driver Board-Red

SKU: COMP0029
Original price was: ₹375.00.Current price is: ₹101.00. (Excl. 18% GST)
  • Module name : dual H bridge motor drive module
  • Work mode : H bridge drive
  • Main control chip : L298N
  • Logical voltage : 5V
  • Drive voltage : 5v-35v
  • Logical current : 0mA-36mA
  • Driving current : 2A(MAX single bridge)
Purchase & earn 1 point!Add to cart

L293D Motor Driver Board

SKU: COMP0031
Original price was: ₹314.00.Current price is: ₹110.00. (Excl. 18% GST)
  • 2 interface for 5V Servo connected to For Arduino’s high-resolution dedicated timer – no jitter.
  • Can drive 4 DC motors or 2 stepper motors or 2 Servo.
  • Up to 4 bi-directional DC motors with individual 8-bit speed selection
  • Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
  • 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 16V DC
Purchase & earn 1 point!Read more

KY-040 Rotary Encoder Module for Arduino

SKU: SEN0008
Original price was: ₹230.00.Current price is: ₹45.00. (Excl. 18% GST)
  1. Model : KY-040.
  2. Type : Incremental Encoder.
  3. Cycles per revolution (CPR) : 20.
  4. Working voltage : 0 – 5V.
  5. Material : PCB + Brass.
  6. Mounting Nut Thread diameter: 6.6mm
  7. Weight : 10 gm.
Add to cart

KY-039 Finger Detecting Heartbeat Module

SKU: SEN0018
Original price was: ₹169.00.Current price is: ₹26.00. (Excl. 18% GST)

 

1. Detects and measures heartbeat or pulse rate.

2. Designed to connect with Arduino and other microcontrollers.

3.  Ideal for health monitoring and biofeedback projects.

4.  Compact and easy to integrate into wearable devices or medical equipment.

5.  Provides reliable pulse readings for precise health tracking.

 

Add to cart

KY-037 Sound Sensor Module

SKU: SEN0004
Original price was: ₹149.00.Current price is: ₹32.00. (Excl. 18% GST)
  1. Main chip: LM393, Electret condenser microphone
  2. Working voltage: DC 3.3-5V
  3. Induction distance is 0.5M
  4. Signal output Indication
  5. Single channel signal output
  6. The output effective signal is low level.